Free Cisco 200-301 Practice Questions 2026 | Cisco Certified Network Associate

Refer to the exhibit.

An engineer is updating the R1 configuration to connect a new server to the management network. The PCs on the management network must be blocked from pinging the default gateway of the new server. Which command must be configured on R1 to complete the task?

A. R1(config)#lp route 172.16.2.2 255.255.255.248 gi0/1

B. R1(config)#jp route 172.16.2.2 255.255.255.255 gi0/0

C. R1(config>#ip route 172.16.2.0 255.255.255.0 192.168.1.15

D. R1(conflg)#ip route 172.16.2.0 255.255.255.0 192.168.1.5

Refer to the exhibit

A network engineer configures the Cisco WLC to authenticate local wireless clients against a RADIUS server Which task must be performed to complete the process?

A. Change the Server Status to Disabled

B. Select Enable next to Management

C. Select Enable next to Network User

D. Change the Support for CoA to Enabled.

Refer to the exhibit.

An engineer assumes a configuration task from a peer Router A must establish an OSPF neighbor relationship with neighbor 172 1 1 1 The output displays the status of the adjacency after 2 hours. What is the next step in the configuration process for the routers to establish an adjacency?

A. Configure router A to use the same MTU size as router B.

B. Set the router B OSPF ID to a nonhost address.

C. Configure a point-to-point link between router A and router B.

D. Set the router B OSPF ID to the same value as its IP address

Drag and drop the statements about networking from the left onto the corresponding networking types on the right.

Refer to the exhibit.

Routers R1 and R3 have the default configuration The router R2 priority is set to 99 Which commands on R3 configure it as the DR in the 10.0 4.0/24 network?

A. R3(config)#interface Gig0/1 R3(config-if)#ip ospf priority 100

B. R3(config)#interface Gig0/0 R3(config-if)#ip ospf priority 100

C. R3(config)#interface Gig0/0 R3(config-if)i=ip ospf priority 1

D. R3(config)#interface Gig0/1 R3(config-if)#ip ospf priority 0

Refer to the exhibit.

The link between PC1 and the switch is up. but it is performing poorly. Which interface condition is causing the performance problem?

A. There is a duplex mismatch on the interface

B. There is an issue with the fiber on the switch interface.

C. There is a speed mismatch on the interface.

D. There is an interface type mismatch

Refer to the exhibit.

Which command configures OSPF on the point-to-point link between routers R1 and R2?

A. router-id 10.0.0.15

B. neighbor 10.1.2.0 cost 180

C. ipospf priority 100

D. network 10.0.0.0 0.0.0.255 area 0

Refer to the exhibit

Which network prefix was learned via EIGRP?

A. 172.16.0.0/16

B. 192.168.2.0/24

C. 207.165.200.0/24

D. 192.168.1.0/24

Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?

A. VLANID

B. SSID

C. RFID

D. WLANID

Refer to the exhibit.

A. Option A

B. Option B

C. Option C

D. Option D