Free Cisco 200-301 Practice Questions 2026 | Cisco Certified Network Associate

What is a characteristic of private IPv4 addressing?

A. traverse the Internet when an outbound ACL is applied

B. issued by IANA in conjunction with an autonomous system number

C. composed of up to 65.536 available addresses

D. used without tracking or registration

Refer to the exhibit.

Between which zones do wireless users expect to experience intermittent connectivity?

A. between zones 1 and 2

B.

between zones 2 and 5

C. between zones 3 and 4

D. between zones 3 and 6

Refer to the exhibit.

An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the GigabitEfriemet3/1/4 port on a switch?

A. The phone and a workstation that is connected to the phone do not have VLAN connectivity

B. The phone and a workstation that is connected to the phone send and receive data in VLAN 50.

C. The phone sends and receives data in VLAN 50, but a workstation connected to the phone has no VLAN connectivity

D. The phone sends and receives data in VLAN 50, but a workstation connected to the phone sends and receives data in VLAN 1

Refer to the exhibit

A. Option A

B. Option B

C. Option C

D. Option D

Refer to the exhibit.

If R1 receives a packet destined to 172.161.1, to which IP address does it send the packet?

A. 192.168.12.2

B. 192.168.13.3

C. 192.168.14.4

D. 192.168.15.5

Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

A. The interface is not participating in OSPF

B. A point-to-point network type is configured

C. The default Hello and Dead timers are in use

D. There are six OSPF neighbors on this interface

Refer to the exhibit.

What are two characteristics of an SSID? (Choose Two)

A. It can be hidden or broadcast in a WLAN

B. It uniquely identifies an access point in a WLAN

C. It uniquely identifies a client in a WLAN

D. It is at most 32 characters long.

E. IT provides secured access to a WLAN

Which command must be entered when a device is configured as an NTP server? AWhich command must be entered when a device is configured as an NTP server?

A. ntp authenticate

B. ntp authenticate

C. ntp authenticate

D. ntp master

An engineer requires a scratch interface to actively attempt to establish a trunk link with a neighbor switch. What command must be configured?

A. switchport mode trunk

B. switchport mode dynamic desirable

C. switchport mode dynamic auto

D. switchport nonegotiate