Free Cisco 200-301 Practice Questions 2026 | Cisco Certified Network Associate

Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?

A. 10.10.225.48 255.255.255.240

B. 10.10.225.32 255.255.255.240

C. 10.10.225.48 255.255.255.224

D. 10.10.225.32 255.255.255.224

Refer to the exhibit.

What is the effect of this configuration?<

A. All ARP packets are dropped by the switch

B. Egress traffic is passed only if the destination is a DHCP server.

C. All ingress and egress traffic is dropped because the interface is untrusted

D. The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

Which action is taken by a switch port enabled for PoE power classification override?

A. When a powered device begins drawing power from a PoE switch port a syslog message is generated

B. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused

C. If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects

D. Should a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

Refer to the exhibit.

Which configuration issue is preventing the OSPF neighbor relationship from being established between the two routers?

A. R2 is using the passive-interface default command

B. R1 has an incorrect network command for interface Gi1/0

C. R2 should have its network command in area 1

D. R1 interface Gil/0 has a larger MTU size

Which IPv6 address type provides communication between subnets and is unable to route on the Internet?

A. global unicast

B. unique local

C. link-local

D. multicast

An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of hree addresses 192.168.30.1, 192.168.3.2, 192.168.3.3 Which configuration should be used?

A. Option A

B. Option B

C. Option C

D. Option D

How does CAPWAP communicate between an access point in local mode and a WLC?

A. The access point must directly connect to the WLC using a copper cable

B. The access point must not be connected to the wired network, as it would create a loop

C. The access point must be connected to the same switch as the WLC

D. The access point has the ability to link to any switch in the network, assuming connectivity to the WLC

Refer to the exhibit.

A. Option A

B. Option B

C. Option C

D. Option D

Which networking function occurs on the data plane?

A. forwarding remote client/server traffic

B. facilitates spanning-tree elections

C. processing inbound SSH management traffic

D. sending and receiving OSPF Hello packets

An engineer observes high usage on the 2.4GHz channels and lower usage on the 5GHz channels. What must be configured to allow clients to preferentially use 5GH2 access points?

A. Re- Anchor Roamed Clients

B. 11ac MU-MIMO

C. OEAP Split Tunnel

D. Client Band Select